Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kesavan.b trichy,
On Load Tap Changer in a device which works under running
condition to increase or decrease the voltage level of the
Primary & Secondary Side... It is preferable to provide @
HT Side why because in HT Side the current rating is low
while in the LT Side current is so much high.... as we done
the operation of tap changing under loading condition at
the LT Side a huge spark will occur & Damage the
Transformer... That is why only the OLTC is placed on HT
Side
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
How to calculate cable size in HT AND LT
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value
What is transient Phenomenon?
What is time response of the control system?
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
What is the RME and explain the full form and what is the RME work?
How we calculate DC inducation moter Amp? Sir pls give me formula......
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
How energy is generated in hydroelectric power plant?
what is sevice settings for mccb?How can be it setted?
Why do power lines not short out when they fall into water?
