What is the working of vaccum distilation coloumn in a
petroleum refinary?
Answer Posted / pushkar deo
It is a process for getting vacuum distilates for
lubricating oil and to get feed for FCC.
Is This Answer Correct ? | 2 Yes | 8 No |
Post New Answer View All Answers
MY generator water cooler inlet line height - 11 mtr inlet water line height - 7 mtr water come into the line from overhead tank, O/H tank height - 20 mtr the first tapping in the inlet line is 2" line which down to 4 mtr level plateform., second tapping in inlet water line goes to a pump 6" line installed at 4 mtr level plateform, pump capacity 200m3/hr, head- 30 mtr, hp-40. the outlet of pump of 6" water line connected to a header of 6 mtr long of 6" line, on this header the six tapping are connected, 4 nos. 3" line goes to 11 mtr height water cooler the pressure of the line is 0.15 to 0.25 kg/cm2, 2" and 4" pipe line connected to a cooler at 4 mtrlevel plateform. my question is, at 11 mtr height level the quantity of water and flow is not sufficient for my cooler, the temp. of cooler is rises much more. you are requested to suggest the modification of pipe line/ pump for take more water flow and pressure (desired pressure is 1 kg/cm2)
how can we calculate reflux ratio? what is difference between internal reflux and external reflux?
What is an effective means of removing silicone from aluminum?
What is the process of including heat exchangers in ammonia refrigeration system?
Re: Sugar Cane Bagasse What are the 1. Specific Heat of Bagasse at 50% moisture, 40% moisture and 25% moisture? 2. What is bu;lk density of bagasse at 50% moisture, 40% moisture and 25% moisture? 3. What is specific gravity of bagasse at 50% moisture, 40% moisture and 25% moisture? 4. What is the specific heat of flue gases generated from boiler fuelled by bagasse? 5. What is the specific gravity of flue gases generated from boiler fuelled by bagasse?
white rust formation over zinc plated and yellow passivated fasteners during CED painting. WHY?
What is the maximum permissible Earth to Neutral voltage in an electrical system.
Explain how can you determine the proper pipe thickness for a slurry line?
What are the effects of oils on the properties of Polyolefins?
Difference between Synthetic foaming agents V/S Protien based foaming agent?
Are there any general rules that should be considered when designing a slurry piping system?
Explain what information is needed to specify a mixer?
i'm a chemical engineer with an aggregate of 80% and i'm going to attend for TCS next week...if i encounter a question like this how i have to answer... WHY YOU CHOOSE SOFTWARE RATHER THAN YOUR CORE COMPANIES?
What compounds are responsible for the odors that come from wastewater treatment plants?
how much maximum power can be generated by 320v, 10kg-cm synchronus motor if shaft is roteted mechanically at 50 to 60 rpm?