What is meant by Resonance what are the different types of
resonance and what are uses of them?
Answer Posted / lasya
when a body is vibrated with some periodic force,if the
natural frequency of that body coincides with the frequency
of the periodic force applied on it, with maximum amplitude
it is known as resonance......there are many types of
resonance-optical, electrical,mechanical,etc............
Is This Answer Correct ? | 11 Yes | 4 No |
Post New Answer View All Answers
Draw transformer phasor diagram.(full load,no load)
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
how to select the isolation tranformer for siemens 802dsl cnotroller
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
What is corkscrew rule?
What is electrical grounding?
What determines the thickness of the lamination or stamping?
How to test the Secure Elite 440 Multi function meter working condition.
What happens if the series current double?
What cmos is and its benefits?
3phase cable calculation formula by motor load
Do you need any help with FEWA Electrical Supervisor exams?
Please send 110 kv sb station full single line drawing(sld)
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH