Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / veeranna.hooli
Harmonic mean is used to calculate the average of a set of
numbers. Here the number of elements will be averaged and
divided by the sum of the reciprocals of the elements. The
Harmonic mean is always the lowest mean.
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
what is the meaning of osr in transformer.
Electronic circuit
What are the basic component of a cro?
Why r u using pf panel. what the uses
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
What is the selection process of breakers. Can any one please give a formulation on same?
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
what is the control circuit for operating the clean room air shower
What is the types of HT motor testing
what is the saturation point of crgo lamination.
what is zinc diffusion?
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is systematic error?
Refernce currents are to be generated using refernce cueernts how can this be done??
