Interested to Buy Any Domain ? << Click Here >> for more details...
10. THE MOST COMMON TYPE OF THREE PHASE IN UNSYMMETRICAL
FAULTS IS ........
- 6 Answers
- 14492 Views
- SSC, I also Faced
- E-Mail Answers
Answer Posted / thuranga
L-G fault is most common in distribution systems,as the
trees and buildings are near by the distribution lines,
while in transmission lines any of the fault can
occur....but occurrence of fault is very rare,as all the
protection steps are taken,and the fault may occur mostly on
the degradation of the suspended disc insulators.....where
the leakage current flows through the pole/tower to the
ground, through insulator.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?
Explain the process of commutation in a dc machine.
defination of transistor controlled series capacitor
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
I want to know all basics of electrical engineering
When lag/lead/lag-lead compensation is employed?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
What is the settings of distance protection relay in 400 kv line
hai iam arunkumar. i have applied for an section enginner in rrb. i want lat 5 years solved question papers. if u have please sedn it to arun30682@gmail.com
what is the meaning of 0.5ohm Resistance
What are the differences between single phase and three phase?
What is the formula to calculate the rating of a three phase air circuit breaker
why high speed tripping relay is used in protection circuit why not normal relay
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
What should be setting for alarm,tripping and cooling fan on for power transformer's oil temp. and winding temp. indicator?
