why transmission line 11Kv OR 33KV,66Kv not in 10kv 20kv?
- 43 Answers
- 114022 Views
- A2Z Group, Baiji Power Plant Gas, Electrical, HCL, Kirloskar, Mepco, NEPC, OAMC, UNI, University of Lahore, I also Faced
- E-Mail Answers
Answer Posted / shahulsnfa
If it is so.. then where is 22kv,44kv,55kv,77kv 88kv, 99kv
why these voltages are not included in transmisson levels?
| Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
A low wet bulb temperature indicates
what is the difference between online & offline caliberation of KWH meters. Can Digital meters be caliberated
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
high voltage transformer input voltage,current and amps rating..distributed transformer input voltage,current and amps rating...
how to set relay setting? and example calculation...
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
how to design the heater in temperature control unit to heat 50KL of water?
Which cable is use for rtcc control panel
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
how we can calculate 2 phase welding transformer rating or total power?
i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?
How do we calculate the Out put voltage of generator, after the excitation is being given?
How to know of any cable size if there are not written on cabl?
