Interested to Buy Any Domain ? << Click Here >> for more details...
WHY 6.6KV MOTORS ARE STAR CONNECTED AND WHY NOT DELTA CONNECTED,
- 15 Answers
- 34501 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / gajanan
we do not have any xmer having ratio 11/6.6 kv. so for
motor of 6.6 kv in star conneced we can use 11 kv supply.
bcoz in star vline=root 3 of v hase
| Is This Answer Correct ? | 4 Yes | 23 No |
Post New Answer View All Answers
what kinds of Transformer oil grade is better for power transformer ?
can we install HT panel & LT panel side by side or how much clearance is required ?
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
show the single line diagram of star delta starter with single phase preventer
What is ramp signal?
what things to be considered when designing UPS
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
How to calculate the copper in HT motors if KW, RPM & Voltage is given
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
what is the difference between 2 way and 4 pole selector switch???
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?
How to Decide(calculate) Bush bar size for copper and aluminiam ?
what are factors to be consider in electrical installation like load factor,diversity factor .....
