Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / seema pal
DCS is distributed control system which is geograhically
distributed and connected through a communication network.
The control stations and its sub stations can be located in
different locations of the plant.It is capable of doing
different functions since it also fuctionally distributed.
Hence, in a short, DCS is geographically and functionally
distributed.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is 3 selection available when configure the burnout protection for controller
how many types of preheaters are in cement industry & what r they can any body explain?
Why is the orifice tab provided?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
How d.p. Transmitter can be applied to close tank?
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
Why humidity limit is 30 to 55 % for raw material storage?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?
How do bending tubing provide better measurement than using tubing fittings such as elbows?
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
you are on site,the plant trips,you are approached by operations,what do you do?
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
