Interested to Buy Any Domain ? << Click Here >> for more details...
How do i calculate sizing of transformer on didstrubution
load for high rise building.What should be MVA Rating of MV
Panel feding by 122 kv.
- 2 Answers
- 5797 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravindra
Transformer rating calculated in KVA. We can measure any
transformer rating from its HT & LT Bushing.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
How to calculate energy stored in an inductance?
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
what is vtg limit of earth and neutral at transformer side?
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
What types domain of laplace transforms? What behavior can laplace transform predict how the system work?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
What is the purpose of using busbar mounting fuse?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
how to calculate fault level?
Who are the manufactures those manufacturing 3Cx2.5sqmm FRLS cables. I heard about FRLS technology adopted only in wires useful for wirings
