Answer Posted / mohammad farman khan
R=RED PHASE
Y=YELLOW PHASE
B=BLUE PHASE
why this Configuration say in Electrical Distribution to
make easy under stand for phase in 3 line. other wise for
distribution in line from transformer always use
U= RED PHASE
V= YELLOW PHASE
W= BLUE PHASE
Is This Answer Correct ? | 34 Yes | 17 No |
Post New Answer View All Answers
How to calculate the sag on transmission Lines.
What is different between resistance grounding system and resistance earthing system?
what is the difference between b c d curves on mcb
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
What is the range of the stator resistance of 3 phase induction motor?
Which do you think is the most significant cause of energy loss in a factory?
during installation time of transformer and alternator which points we have to observed?
You are of electrical field and you are going for software? Why
why industry prefer ht motor instead of lt motor.
what is the difference between skin effect
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
why tertiary winding is used in transformer with diagram?
Why do we perform an open-circuit test and short-circuit test on the transformer?
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
what may the reason for vector shift in a generator?