Interested to Buy Any Domain ? << Click Here >> for more details...
How do i calculate sizing of transformer on didstrubution
load for high rise building.What should be MVA Rating of MV
Panel feding by 122 kv.
- 2 Answers
- 5905 Views
- I also Faced
- E-Mail Answers
Answer Posted / mf.khan
Transformer size can be calculated on Maximum Dammand Load.
For 122KV MV Switchgear fault level should be 350MVA.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why power not passes in plastic and rubber material
what is the difference between b c d curves on mcb
how to calculate kvar in Akiva
In HI POT test what is reason for applying the AC VOLTS and DC VOLTS in different applications what is the nessesity for this ?
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
what is the power rating of CPU, CRT type moniter, LCD type moniter,scanner Approx.
how to measure the current by compact digital equipment with dislay which fit inside any equipment
What is A check, B check, C Check & D check for a diesel Generat
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Can I use star delta connected induction motor for dual supply voltage?
