How the STP determinw that which Port should be Root Port,
which port should be Designeted Port , Blocking Port and
Forwarding Port in Layer 2 STP topology
- 7 Answers
- 9363 Views
- Tech Mahindra, Wipro, I also Faced
- E-Mail Answers
Answer Posted / guest
the port that has the least cost toward the root bridge is
considered theroot port andthe one that is in the opposite
direction is considered the designated port.
now the one that has the better cost (remember lower is the
better)among the two parellel connections is considered the
forwarding port and the one that has higher cost is takes
as the blocking.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
What is a vlan?
What is an autonomous system?
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
Explain how many types of ips?
What is default packet size of ipv6?
Explain the major types of networks and explain?
Explain the terms unicast, multicast, broadcast and multicast.
Can you explain the broader steps of how L2F establishes the tunnel?
What are the types of resource sharing?
1350 Value in which type of access-list?
Explain the terms unicast, multicast, broadcast.
What is the igp (interior gateway protocol)?
Mention the conversion steps of data encapsulation?
How does RIP differ from IGRP?
Explain the benefits of vlan?
