how to given power supply of any type two wire transmitter
in field?
- 4 Answers
- 7919 Views
- Dr Reddys, I also Faced
- E-Mail Answers
Answer Posted / touch2gobi
In 2 Wire system, we have only two terminals
1 - +24 Vdc
2 - Output signal (4 - 20mA)
No Need ground signal etc....
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
How to convert milliampares into flow??
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
What is 3 selection available when configure the burnout protection for controller
i want to find out iffco get test paper
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
What is ultrasonic flowmeter?
what is the difference between profibus and controlnet networking.
What is the diffrence between ff tx and non ff tx
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
What is the difference between working pressure and calibration pressure of a control valve
In apron feeder how TPH is calculated?
How many ohms are required for proper earthing?
Whatis the reset ofset and control system in instrumentation
