Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / shanmugakalaivanan b.e eee abu
used for current rating above 100 amperes
its protected by thermal protection .
we can adjust the tripping
overload and short-circuit protection .
its normally used for current protection incoming side
| Is This Answer Correct ? | 42 Yes | 4 No |
Post New Answer View All Answers
How to test lightning Arrester?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
Why ground terminal is used in pot meter 10k ohms
what is 3rd Harmonics? how it is generated in alternator
can i use ups power as a raw power for another ups
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
what is W.T?specify the acceptable range?
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
Enlists the applications of sampled data systems?
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
what is Fault level? why it is calculated? how will u decide same for our plant?
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
