Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / karthikeyan..n
Injection pressure/injection rate too high
Barrel temperature too high
Insufficient clamping pressure
Mould sliding cores clearance too large Imprecise mould
alignment
Foreign material caused clearance on mould mating surface
Mould temperature too high Air venting design too large
Material over packed the mould cavity
Mould parting defects after age
Hopper temperature too high
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.
What is the thermal efficiency of a diesel engine?
Is there a metal that does not contain iron?
What is the formula for 1 HP of a two-cycle engine?
What are the causes of damage to propellers?
What is polytropic process ? Under what conditions it approaches isobaric, isothermal, and isometric process ? In which reversible process no work is done ?
Why axial flow compressor is preferred for gas turbines for aeroplanes ?
send interview questins about pro_e to me mohanrvs_1984@yahoo.co.in
What are materials used for manufacturing of gears ?
One unit of btu is how many joules?
What is least count?
Why PWHT IS NOT DONE TO STAINLESS STEEL MATERIAL?
what are the major duties of a mechanical engineer in a power plant.?
What is brain of the computer?
What is the purpose of a de-superheater?
