Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / karthikeyan..n
Injection pressure/injection rate too high
Barrel temperature too high
Insufficient clamping pressure
Mould sliding cores clearance too large Imprecise mould
alignment
Foreign material caused clearance on mould mating surface
Mould temperature too high Air venting design too large
Material over packed the mould cavity
Mould parting defects after age
Hopper temperature too high
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Explain knurling.
What do you know about DG ,A,B,C, D, Check and safety of generator.?
Heavy fuel oil sulfur content and counter measures?
Causes of dilution of lubricating oil in a steam turbine?
Relatesd Applied Mechanics
Can you give me detail of Diesel Quality parameter in use of DG sets.
How much is the specific fuel consumption of an average diesel engine?
how to design a crankshaft?
what is STOCT TURN OVER RATIO
I need BHEL Engineer Trainee written test papers in Mechanical stream.
What is the critical speed. Compare the critical speed of hollw shaft and solid shaft.
Explain the opening and closing of water to the bowl of the purifier
tell me about a time when u had too many things to do and u were required opinion prioritized your talks
What color are thermal oil piping lines?
can any one pls refer me any sites which have notes regarding Body-in-white(welding fixtures)...pls
