Interested to Buy Any Domain ? << Click Here >> for more details...
Why secondary of a CT in a power system acts as an open
circuit after core saturation?
- 2 Answers
- 5703 Views
- I also Faced
- E-Mail Answers
Answer Posted / arpita
Under normal operating condition m.m.f or ampere- turn
both primary and secondary oppose each other. When
secondary of C.T is open circuited then there is no
demagnetiging ampere-turn to oppose the primary ampere-turn
and therefore, the primary ampere-turns now become active
in producing a very high flux density in the core which
result in very high inductance e.m.f. in the secondary
winding.
This high induced e.m.f. is likely to cause
a) Overheating of core
b) Breakdown of insulation
c) An electric shock to the attending personnel.
For these reason secondary of C.T in power system not act
as an open circuit.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
why they were using TRIAC instead relay in some controllers and what is the advantages.
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
what is negative and zero impedance in 3 phase induction motor ??
What is the name of transformers oil filteration equipment?
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
how you configure motorvision relay (L&T make)from DCS
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
How to design a Unit auxiliary transformer for a power house having a unit of 65 MW and Generating voltage of 11 KV and Secondary voltage of 433V
Define end float in a motor?
hello friend i wish to study a course related to the electrical construction, controlling and monitoring , which course i want to study? pls give me the name of institute?
what work will do diffrential realay DG set
thyristor controlled APFC panel design parameter?
hi....I am from india..i have completed my engineering in electrical and electronics field with 58.4% and my IELTS score is 5.5 bands....Recently i received my I-20 in computer and information science from Troy university in Alabama.On 18th i have a visa interview can u please tell me what type of questions i have to answer ??????
Why the power factor improvement is so important in industrial loads
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
