Interested to Buy Any Domain ? << Click Here >> for more details...
What is the torque required at M6, M8, M10, M12, M14, M16,
M18, M20, M22, M24 Bolt or give me any chart for
this?????????
- 4 Answers
- 14062 Views
- I also Faced
- E-Mail Answers
Answer Posted / td
Standard torque for std grade 2 hardware: Tighten until
threads strip, then back off 1/2 turn.
| Is This Answer Correct ? | 9 Yes | 7 No |
Post New Answer View All Answers
What is the difference between gear motor and a stepper motor? Like i want to use gear motor for its excessive torque to move my robot. Can i use stepper motor instead?
I want to apply for Asst.vehicle inspector,i would like to know the requirements and the syllabus.. if any body know that please mai me.. naany4u@rediffmail.com please friends
what is the use of offset follower in cam? why and where we have to use this type of follower?
Explain the procedure of charging reciprocating compressor?
What are the causes of low compression in the main engine?
Causes of M/E high exhaust valve temperature
distinguish the knock phenomena of ci and si engine?
how to minibar working
What causes cylinder liner-wear down?
THIS IS HARI PRASAD. I KNOW THAT HVAC MEANS HEATING VENTILATION & AIR- CONDITIONING. I NEED DESIGN CONSIDERATION OF HVAC UNIT.
Which parameter remains constant in isochoric process ?
with the aid of schematic and block diagram describe the control system involved in a student passing a control system engineering examination.use standard terminologies and specify all the system component involved.
what is the trignometry of lifting tools using the wire rope ? any formula for trignometry ?
What is the purpose of gravity tank in the stern tube
Why do you want to leave your last job?
