what happens when current(ac or dc)flowing through a
boucket of water?please describe it.
Answer Posted / sravanthi
Please tell me the reason y is it so??
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to calculate energy stored in a capacitance
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
Please brief what is sinewave
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
How to Calculate KA Rating of Main LT Panel
What are the causes for the failures of sandwich type (Al) busducts?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
Leakage current,un balance current which relay using for high voltage transmission?
one split ac how can told of this ac which Tr tell me us
why co incidence factor considered in transformer sizing?