Interested to Buy Any Domain ? << Click Here >> for more details...
Why secondary of a CT in a power system acts as an open
circuit after core saturation?
- 2 Answers
- 5680 Views
- I also Faced
- E-Mail Answers
Answer Posted / gajanan
there are 2 possibilities
1.if we keep secondary of ct open, then only primary mmf
will be present in core which saturates the core
2.in fault condition due to high frequencu current core
saturates means permeability of core decreases very much as
good as wood
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how to produsing geretor power
Explain about 3 phase motor fault current calculation with examples?
what parameters are should nessary for control technic dc drive(in rolling mills)?
how to determine motor size for a fan application?
Please provided formula for calculate the cable size from step up transformer to M.V panel, run overhead aluminum cables, total load is 5mega watt, total length 900 feet.
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
what is load despatching
Do you know what is dry-out test in x'mer
What is Negative Potential Bias
how to select overload-relay for perticular motor 1.for D.O.L. starter 2. for Star-delta starter ????
What is the maximum operating temperature for a thermoplastic insulated cable?
why ups rating in kva? and why ups are in parellel?.why isolation transformer is used in ups?
what is diff. between earthing grid,earthing mess, earting grid?
