If one lamp connect between two phases it will glow or not?
- 9 Answers
- 24381 Views
- I also Faced
- E-Mail Answers
Answer Posted / shubham
Assuming a general situation without any rating problems(
becoz like this many problems would be there)..and lamp
means a general incandescent lamp..
for all those moments when there is a voltage difference
between the two phases the lamp will glow with output lux
proportional to the magnitude of voltage difference.i.e.
what we are going to see is a sinusoidal variation in output
lux of the bulb. i.e. from 0lux to maximum then again to
zero and so on
that's it
| Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
why the name trunking bus PT
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
What is lifting power for 1 wb/m2 and 1 A magnet?
What is the basic rule for block diagram reduction technique?
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
tell me about eletrical contractor
What is core CT & it's function?
Why we use circular(Stepped) cross section in transformer core?
what is the max. acceptable leakage current in 33kv bus bar
what is the difference between ups & inverter
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
what is is the potential diffrence between two phase ?
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
