Interested to Buy Any Domain ? << Click Here >> for more details...
what is derating?, why it is neccesary, it is same for all
means for drives, motors,and cables.
- 1 Answers
- 3907 Views
- I also Faced
- E-Mail Answers
Answer Posted / mrinal
The current currying of cables will change depending upon
the site temperature (location of site), type of run(it
will run through DUCT, TRENCH, BURRIED ect.), number of
tray, depth of trench, distance between cables. Considering
this condition actual current currying capacity of cable
reduce than current currying capacity (which given to cable
cataloge) this is called deraing.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how ups works ? various parts of ups and working principle
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
how to put cable sizing and cable glands size for respective cable & Cable Lug size in a DB sectors???
what is the purpose of bypass mode in energy lighting transformer?
Why the frequency of ac in india is 50 hz but in some other countries it is 60 hz.
various transmission tower like .,D tower ,K.C.O tower ,C.C.O tower,K.C.R tower ,C.C.R tower ,H.C.O tower in different tons.
What is a copper loss or i2r loss pc?
Battery is a voltage source? give one example of current source and why?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
What are the major reasons for balancing hydro-thermal mix?
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
my bachelors was done with EEE now i got admit in NU with CS as course. how to answer this qns 1) why u choose cs? 2) why u changed from eee to cs
what about GD square and its important for motor design?
