Answer Posted / sunil guru
SKIN EFFECT--- IT IS THE UNEQUAL DISTRIBUTION OF CURRENT...IN THIS THE CURRENT FLOWS AT THE SURFACE OF THE CONDUCTOR RATHER THAN BULK.....SO CAUSES HEATING OF THE CONDUCTOR AND THUS THE LOSSES ARE INCREASED...
SKIN EFFECT MAINLY DEPENDS ON
1.SURFACE OF THE CONDUCTOR
2.MATERIALS USED IN THE CONDUCTOR
3.FREQUENCY
FOR ANY DISAGREEMENT MAIL ME AT PARMAR20072008@YAHOO.COM
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
What is kirchoff ’s current law (kcl)?
Should power factor be low or high?
What is the percentage loss for aluminium wire for HT line more than 11KVa
define displacement & magnitude ?
Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?
what is the criteria for selection of conductor used for ehv ac electrical dischrge
salam,hi, i need to know what the spesification of 300amp msb...
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
What are the basic properties of signal flow graph?
Where burned of electricity,when,who, & why.
What is the importance of earthing?
