In India which type of PLCC IS used?
- 2 Answers
- 10194 Views
- Cipla, Ford, Jayashree, I also Faced
- E-Mail Answers
Answer Posted / sunil kaushik
high hz power line carrier communications is used in india
| Is This Answer Correct ? | 9 Yes | 6 No |
Post New Answer View All Answers
WHAT IS THE TOTAL POWER GENERATION IN CHHATTISGARH?
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw
block diagram of 2 ups system connected in parallel mode?
how many safety really of DG sets.
why we use sinosidal voltage / current instead of others in system?
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
errection check list for transformer maintenance
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
how do u gauge the size of the cable ?for eg. consider a 300 sqmm L.T Cable.How do u determine the size of the cable seeing it pratically?
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
