Interested to Buy Any Domain ? << Click Here >> for more details...
when voltage increases then current also increases then what is
the need of over voltage relay and over current relay?
can we measure over voltage and over current by measuring current
only?
- 1 Answers
- 6771 Views
- I also Faced
- E-Mail Answers
Answer Posted / nithi
NO.We can't sense the over voltage by just measuring the
current only.because,
The current increases not only for over voltages but
also for under voltage(As most of the loads are non-linear
in nature).
So,the over voltage protection & over current
protection are completely different.
over voltage relay meant for sensing over voltages &
protect the system from insulation break down and firing.
over current relay meant for sensing any internal
short circuit,over load condition ,earth fault thereby
reducing the system failure & risk of fire.
So, for a better protection of the system,It should have
both over voltage & over current relay.
| Is This Answer Correct ? | 15 Yes | 0 No |
Post New Answer View All Answers
Difference between control junction box (cjb) and power junction box(pjb)?
what may the reason for vector shift in a generator?
what curve and rateing would you use for a three phase 0.75kw motor?
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
Why do we require transformer with less specific weight if supply frequency is increased?
what clearance required for 4.5 mva dry type transformer?
help me with the question that might be ask on the interview for technical position
Merits & Demarits of Oil circuit & Air circuit breakers ?
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
What are the types of piano switches?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
A jet of fluid strikes a plate What was the force required to counter it?
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
What happens to a line-frequency of high-frequency transformer when it is first energized/ re-energize?
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
