we have a 2000kva step down transformer at our site. The HT
side is charged from 22000V. So the primary current will be
52.48A. So why the HT breaker(SF6 ABB) is rated of
1250Amps ?
- 2 Answers
- 4652 Views
- I also Faced
- E-Mail Answers
Answer Posted / javad
i thing the cb is coming at standered rating.but if fault occures the current will go beyond 1250 defenitly.therefore no problems
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
Dry type transformers
What are the advantages and disadvantages of the ac motors?
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
Please give me a erda placement paper
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
along with technical test papers
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
what happen when increase or decrease size of lamp,light.glass.
In Power cable specification what is U0/U and Um.
How we select the vector group of 3phase power transformer?
how can we select the appropriate VCB ?
