How electrical power is generated by an A.C Generator ?
- 1 Answers
- 4060 Views
- Hindalco, I also Faced
- E-Mail Answers
Answer Posted / jaru
for the generation of elect power we need a prime mover
which supplies mechanical power input to the alternator, can
be steam turbines ,or hydroturbines.when poles of the rotor
moves under the armature conductors which r placed on the
stator ,field flux cut the armature conductor,therefore
voltage is generated.and is of sinusoidal in nature...due to
polarity change of rotor poles that is N-S-N-S..
| Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
What happens if the series current double?
relation between power station capacity and voltage level?
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
What is “pu” in electrical engineering?
what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
What is the transfer function?
State the frequency for rc phase shift oscillator?
Do u know any one? how to find out in motor rated amps? formula?
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
As an electrical engineer what are the responsibilities which i can hold in TCS?
