What are the commercial names of overhead conductors used
in India?
- 3 Answers
- 10980 Views
- UPSC, I also Faced
- E-Mail Answers
Answer Posted / navdeep
moose
panther
bermisis
dog
zebra
squirrel..etc
| Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
What is trip and closing coil in cb? Why need of them
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
is it possible to test of bus bar in high rise building without completed full floor ?
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
I need bhel electrical test pattern & paper
If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
What is dc current source? Differentiate between ideal and non ideal current sources?
What is the distance between body earthing and neutral earthing.?
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What is the effect of positive feedback on stability of the system?
HOW TO CALCULATE HV CABLE SIZING?
