Interested to Buy Any Domain ? << Click Here >> for more details...
why we are used D.c. voltage in L.T.side or controling
side.we can use UPS also ,in place d.c. voltage
- 5 Answers
- 8712 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / nitin bhoraokar
Gangadhar predicted rightly.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How the circuit breaker is selected for Induction motor of 100 kW, 415 volt, 0.85 power factor, 0.95 efficiency ?
What is the use of bundle conductors?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
how to select correct size of power cable for inverter duty motor
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
how is calculated the quantity of weight in hot test xlpe?
How to do maintenance of transformer feeder.
If UG power cable both ends are to be earthed or what? If not why?
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
Please send 110 kv sb station full single line drawing(sld)
Define noise?
what is the basic need of domestic loads 1- voltage 2- current
what is the thumb rule for determination resistance of resistor?
