Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rahul
all the answers above are correct...
Step up, step down
protect the main connection
Variable transformer- to reduce the starting load.
Isolation transformer - to prevent the machines from getting damaged from spikes as transformers filter them.
all these answers must be answered simultaneously to describe the transformer completely... & i really dont know which is saying the answers above that of mine are wrong.. they are right but are partially answered
| Is This Answer Correct ? | 18 Yes | 8 No |
Post New Answer View All Answers
why various test are performed on electrical panels & power cables before commissioning on site & what are these test???
What we mean by vintage of an engine+Generator?
how to select electronic timer(Star-Delta) setting for diff. rating motors
How to design the earth grid for lightning protection in an industry
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
What will be the diameter of pipe between conservation tank and transformer
how do i commission a distribution transformer knowing all its ratings and transformation ratios?d
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
why not starting switch first connect in direct on line starter?????
What are Contactors? How they works and what its highest rating?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
