Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nithi
DC is more dangerous than AC.
The magnitude of AC voltage is continuosly varying & it
reaches zero value(sleep) frequently.so,there is a chance
(In low voltage system) to escape from the shock if we are
active.
but,this is not possible in case of DC system.It has a
constant magnitude& It awake always & very active than us.
| Is This Answer Correct ? | 30 Yes | 1 No |
Post New Answer View All Answers
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
can the measured percentage error during calibration of single phase energy meter be negative?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
Can we use Ccapacitive voltage transformer directly for metering purpose?
Can anybody post questions asked in Engineers India Limited Interview? Thanks in advance.
what is fault level of power system ?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
what do w do when the output of generator is fluctuating?
what is the difference between ac motor and dc generator
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
what material is the electrical housing wire made of? is there any difference for the telephone lines?
What is difference between insulating medium and fault current interruption medium in a switching device.
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
