Interested to Buy Any Domain ? << Click Here >> for more details...
HELLO FRIENDS PLZ EXPLAINE ME WHAT IS ORIFICE?AND HOW WE
ARE USING IT IN INSTRUMENTATION
- 5 Answers
- 8831 Views
- Wartsila, I also Faced
- E-Mail Answers
Answer Posted / visakh ctjv
orifice is a used as a primary element for flow
measurement.the differential pressure created by the
orifice is propotional to the flow rate.it is very cheap
and easy to install
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
How to work togather like sov,limit switch,proxy switch and booster in xv
Emergency Shutdown Systems/ Plant Shutdown System.
what are the steps I have to deal with?
How to calibrate Magnetic flow Transmitter in Field
Explain the key components of control loop?
what is cold loop? difference between hot and cold loop?
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
can any send me a forbes marshall dtron 316 manual
what is function of SCADA , and how is it work, explain with difination
what will the sending unit in the fuel gauge utilizes?
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
Calibration procedure for electro magnetic flow meter
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
