Interested to Buy Any Domain ? << Click Here >> for more details...
In Round type three phase transformer why the LV side is
inner part and HV outer part in the design of transformer?
why they cant be opposite?
- 2 Answers
- 7276 Views
- I also Faced
- E-Mail Answers
Answer Posted / pratik panchal
HV coil needs denser insulation.
If it is placed between core & LV coil (i.e HV inside and
LV outside), both the sides will require denser insulation.
Hence, if it is placed outside (i.e. HV outside and LV
inside), only its inne side will require denser insulation
to isolate it from LV.
Pratik Panchal
pratikpanchal@hotmail.com
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
what is lrs tank water resistance.
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
How is magnetic leakage reduced?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
difference between semiconductor & conductor & insulator?
what is parellel power factor correction?
what is interfacing in computer studies?
how to find the voltage's of a transmission line plzz help with pictures i am not able to understand
Why in ESP Positive earthed
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
I need HT sphere gap calibration table. Can any body help me.
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
Define bibo stability.
why and how current drawn by battery charger depends upon the altitude where it is located?
