What is the most common layer 2 device?
A. Hub
B. Bridge
C. Switch
D. Router
- 20 Answers
- 23032 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / guest
physical
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What are the three sources of signal degradation on a data link?
What is encapsulation and de-encapsulation?
Which type for communication switch do?
Name the vtp modes?
Explain the types of nat?
What is the draw back of eigrp protocol?
What is topology in ccna?
How can you assign a vlan to a switch port?
Explain what is route poisoning?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Why is distributed processing useful?
How network gateway is different from routers?
What is the passive topology in ccna?
What is the name of algorithm of eigrp protocol?
Tell me which protocol works only on cisco routers?
