Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the 2 commands that display the clock rate
configured on
the serial0 interface?
A.) show serial0
B.) show interface serial0
C.) show clock rate serial 0
D.) show controllers serial 0
E.) show running-config
- 5 Answers
- 9630 Views
- I also Faced
- E-Mail Answers
Answer Posted / ajay dalvi
answer is D and E show controllers will display the DCE end
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Can you explain PAP?
What is the function of a router?
In stead of 0.0.0.0 wild card mask what you can write after ip?
What requirements should a VPN fulfill?
What causes a triggered update to reset the router hold-down timer?
Explain the benefits of vlan?
Why mac address called physical address?
What do you understand by redundancy?
Which protocol works only on cisco routers?
What is the minimum request timer?
What is subnetting and why it is use?
Mention what is bootp?
What is segmentation and fragmentation?
What are the advantages of a layered model in the networking industry?
Mention what command you must use if you want to delete or remove the configuration data that is stored in the nvram?
