Interested to Buy Any Domain ? << Click Here >> for more details...
What is the fundamental cause of transients in power system?
- 3 Answers
- 7175 Views
- I also Faced
- E-Mail Answers
Answer Posted / iamdon
A power system consists of many circuit elements which can
be approximately modeled as a complicated network(grid) of
Sources, Inductors,capacitors,Resistors etc.The inductor and
capacitor stores energy in their magnetic and electric fields
respectively.
Whenever a power system deviates from its normal operating
condition(due to faualts,perturbations,switching etc)the
redistribution of stored engery takes place.This is because
configuration of circuit changes considerably from pre
perturbation to post perturbation condition.
The redistribution of energy is not an instantaneous
phenomenon.It takes some time(order of micro or milli sec
depending upon the time constants of circuit elements)
to redistribute the stored energy in circuit elements, after
perturbation,which is described by transients in power
system.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
How to Decide(calculate) Bush bar size for copper and aluminiam ?
what is the IPC ? & what the uses ?
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
How does a television work?
how can i improve the power factor in domestic (230v)
as a electrical student why should i hire you?
how to calculate IR value of 33KV cable ??
Explain the fundamental difference between emf (electro motive force) and pd (potential difference) ?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
How can you sized or estimate the ligthning arrester current rating?
What is the difference between voltages or potential difference? And what are they?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
