why microprocessors are named as 8085 ,8086 etc?
what's the reason for this???
- 15 Answers
- 40101 Views
- Bhel, HCL, I also Faced
- E-Mail Answers
Answer Posted / shyamkr
ok.lets consider this ...but how will u explain about 8086 and 8088??
and why only there few of microprocessors r there not all 80 seiers starting from 8080 to 8090??
plsexplain this too???
| Is This Answer Correct ? | 17 Yes | 14 No |
Post New Answer View All Answers
Is it advantages of having star-delta vfd than normal star vfd , if yes why?
What Is Connection APFC Panel In Compony.
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Why a tesa lamp is glow between two phase?
What is difference between YNyn0 and YNyn ??
how ct burden,magnetising current,ratio and knee point voltage are related & derived
Why HT 11 KV Slipring Motors are connected in star ?
hello!my name is sheikh iam preparing for indian engineering servieces,please send me the old question papers..to sheikhshaazforjobs@gmail.com
What are the applications of autotransformers?
Earth leakage relay basic knowledge principle
why should the primary of transformer be connected in delta in a heat run test?
what is mean by descripiency relay? & wht is its ansi code?
why are distributed windings generally used in alternators?
What is the formula to calculate the rating of power cable for three phase current.
how does a shunt reactor maintains the bus voltage???
