Answer Posted / modipraveen
M10, M15, M20, M25, M30, M35, M40, M45, M50, M55, M60, M65
etc., its depend on load, span, depth of member
Is This Answer Correct ? | 24 Yes | 7 No |
Post New Answer View All Answers
why demand factor less then 1 ?
can any one give me sample question paper of BHEL at mdansari86@gmail.com as i m appearing for the same exam.
five requirements of infill panels for walls?
cause of cylinder test failure
For elevated service Reservoirs what will be the output of each skilled carpenter and bar bender.
RR masonry rate analysis
How much percentage of brick bats allowed in CD-75 bricks
How high should the water tank be to provide a 60 psi at base of this water tower?
For submitting the project loan for bank Residential bldg,Suppose we take Provinding RCC mix 1:2:4 for footings No of footings,length ,Breadth,Height ,qty in cum, at last unit/Rate(Rs) ,i would like to know how do we get the unit/Rate
What is soil enforcement?
why top layer of block work shoud be full size if any cut block adjustable than another layer?
find the discharge of water through a horizental venturimeter having 400mm dia at the inlet main and 150mm dia at thorat.if the diffrential gauge between inlet and thorat shows a pressure head of 25cm mercury. assume coefficient discharge 0.98 and specfic gravity of mercury as 13.6.
what is the formula for Mass of cement grout (Dg)=???
How to convert 20 dia bar to 16 dia bar in beam without reducing the steel weight
Explain what is the release of lien?