How the size of electic machine vary with the sped?
Between slow and fast running machines of equal ratings,
which one is more economical to design?
- 1 Answers
- 2798 Views
- I also Faced
- E-Mail Answers
Answer Posted / iamdon
With the increase in speed, the size of the machine reduces.
Fast running machines are cheaper and more economical to
design.However the maximum speed is limited by the
mechanical stress in the core.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
What is reactance, reluctance,capistance, pls give answeer in hinglish and be simply Jo asani we smajh m aa jaye
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
what is subtransient , transient and steady stateac components
What do you mean by phasors?
I am a electrical engg. diploma holder,applied for junior engineer (electrical),Kolkata RRB. Have I to attend all electrical,mechanical&civil portion in written exam.???
why we use sinosidal voltage / current instead of others in system?
Please provided formula for calculate the cable size from step up transformer to M.V panel, run overhead aluminum cables, total load is 5mega watt, total length 900 feet.
Which power will flow first if we switch on a motor Active or Reactive? How?
WHAT IS DIFFERENCE BETWEEN CAPACITOR AND CAPACITANCE?
Differentiate between voltage and current feedback in amplifiers?
what is the write prosidure of stringing of 8meter pcc pole.
What is Plank's Law?
