Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vijaykumar g
HT voltage is the voltage above 400V and LT voltage is the
voltage below 400V like 230V,110V........
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
why zero sequence impedance measurement is not applicable for single phase GT
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
why do we have spikes enough to burn electronic boards, when generators are not grounded
what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
Why armature rheostat is kept in maximum position?
design a LV scheme for a 15 storied building?
how flow current in 220 kv line to line
In CTs tan delta point should be earthed , what is the reason behind it?
how many joints are allowed in underground HT cable of 1 KM
DEAR SIR,I GOT THE CALL LETTER FROM RRB, SECUNDERABD AS A JE-II SO PLEASE PROVIDE ME SOME MODEL QUESTION AND ANSWER PAPERS AND LAST YEAR QUESTION PAPERS
