Interested to Buy Any Domain ? << Click Here >> for more details...
What is the speed of 3 phase IM(Induction motor) at no load?
How will the Motor meet the increased load(Explain through
fundamental)?
- 2 Answers
- 5117 Views
- I also Faced
- E-Mail Answers
Answer Posted / iamdon
At no load the speed of IM is VERY CLOSE TO SYNCHRONOUS
SPEED but not equal to synchronous speed.
As the mechanical load on the motor shaft is increased,the
motor slow down.Due to which the relative motion between
rotating magnetic field and rotor conductor increases.Thus
more emf will induce in rotor conductor according to
Faraday's laws.Since rotor conductors are short circuited
so more current is induced according to Lenz law.The
induced current will flow through rotor conductor causing
more electromechanical torque to be developed.In this way
motor meets the increased load demand.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
hi frnz,can somebody give me any project work? i am a 2nd year student & interested in practical works...plz give me some projects
features of hbc fuses
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
How will polarity test of Dy5 Transformer ?
why does make gain margin and phase margin on same plot.?
What magnetic circuit is formed in berry-type constructions and why?
how r charge carriers produced
Explain Energy and Power signals?
what is advertised hop count
how can we calculate the ratio of caustic soda and water in lrs.
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
why do we carry out winding resistance test?
What are m circles?
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
