Answer Posted / iamdon
Power factor is the factor by which real power differ from
the apparent power.That is why it is called power factor.Real
power can NEVER BE GREATER than the apparant power.Since the
apparent power remains fixed,it is the power factor, which
decides the amount of real power calulation in the network.
That is why power factor is so much of importance in electrical
engineering.
Real power=(power factor)*(apparant power)
W = (pf) * (VA)
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 21 Yes | 1 No |
Post New Answer View All Answers
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
Hoe do calculate the Cable size for Amps rating ?
what are the range of memory address in plc for L&T lx7 4A
What is distance between electrical panel to land ?
1.Z transform always lies around ? a) origin b) pole c) zero d) z=1. Multiples Mcqs which is bother me can’t find answers on internet. Some help required with little explanation . Note: this is not homework or related to any test. Thanks
Can you explain about pole discrepancy scheme
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
Draw a SLD of HT distribution EB grid up to users Transformer?
How to calculate loses in transformer of 160 KVA ?
TRAFO 1. WHY BREATHER IS USED. 2. WHY OIL GOES DOWN IN CONSERVATOR TANK. 3. WHY WE ARE TAKING OIL SAMPLE TAKING FROM BOTTOM OF TRANSFORMER. 4. HOW TO CHECK IR VALUE OF TRANSFORMER. 5. WHY OLTC HAVING BUCHHOLZ TRIP ONLY; WHY NO ALARM. 6. OFF LOAD TAP CHANGER OPERATION PROCEDURE. 7. TR. SHUTDOWN / ISOLATION PROCEDURE. 8. WHEN THREE TRS. IN PARALLEL, ONE TR. IS NOT SHARING THE LOAD – WHAT IS REASON AND WHAT YOU WILL DO. 9. WHY TR. HAS OLTC IN HV SIDE. 10. WHAT IS % IMPEDANCE. 11. WHY TR. RATING IN MVA. 12. WHAT IS VECTOR GROUP IN TR. 13. CONDITION FOR PARALLEL OPERATION OF TRS. 14. WHAT IS TERTIARY WINDING. WHERE IT WILL BE. 15. IF TR. TRIP ON BUCHHOLZ OR TAP CHANGER RELAY, WHAT YOU WILL DO. 16. DIFFERENCE BETWEEN OIL TEMP. AND WINDING TEMP. PROTECTION 17. HOW WINDING TEMP. IS MEASURED IN CAST RESIN TR. 18. DIFFERENT TYPES OF FAULTS IN TR. Trafo - Page-1 of 2 19. WHAT HAPPENS WHEN TR. CHARGED FROM LV. 20. WHAT WILL YOU DO IF MEGGER READING SHOWS ZERO BETWEEN LV WINDING AND EARTH. 21. CAN WE INTERCHANGE BUCHHOLZ RELAY OF MAIN TANK AND OLTC TANK. 22. IF THE LINE BETWEEN BREATHER AND CONSERVATOR TANK 23. LOCKED, WHAT WILL HAPPEN DURING LOAD CYCLE. 24. WHAT IS THE FUNCTION OF OIL SEAL IN BREATHER. 25. WHAT ARE LOCATIONS FOR BUCHHOLZ RELAY FIXED IN POWER TR. 26. WHAT ARE CHECKS IN POWER TR. DURING MAINTENANCE. 27. WHAT IS IMPORTANT WHEN WE CHECK OLTC OPERATION DURING MAINTENANCE. Trafo - Page 2 of 2
what is the difference between neutral and earth
Why do we perform an open-circuit test and short-circuit test on the transformer?
what is meant by skew width in machines?
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
How can a equal potential zone be carried out in conductors?
