Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / shailendra kumar
Zero is the last value of any instrument. he he he...
Actually, The least value that a micrometer can meaure is
0.001 mm (10^-6 meter).
| Is This Answer Correct ? | 12 Yes | 3 No |
Post New Answer View All Answers
If P will increase then what will happen with PID?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
What is the constant voltage unit?
what are the values of fuel flow rate in various places in boiler.
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
What is Cavitation in a control valve?
how the arrangement of equipments done in control room
Why grounding is necessary? Give example with diagram.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
