Interested to Buy Any Domain ? << Click Here >> for more details...
what is alignment of two shafts and procedure and how we
have to give the correction for misalignment
- 5 Answers
- 21548 Views
- Airtel, RRB, I also Faced
- E-Mail Answers
Answer Posted / phani kumar
IN A DIAL GAUGE +SIDE READING MEANS LOAD IS COMING ON DIAL -
SIDE MEANS REVERSE OF + SIDE.
1st MEASURE THE CENTRE DISTANCE BETWEEN BEARING PEDESTLS
WHERE THE SHIM IS TO BE ADDED, DIA OF THE SHAFT WHER THE
DIAL IS PLACED.
NOW THERE ARE TWO CORRECTION 1.RADIAL 2. AXIAL
FOR RADIAL
CONSIDER DIAL IS PLACED ON PUMP SHAFT & CLAMP ON MOTOR
SHAFT FOR BOTH RADIAL & AXIAL. ROTATE IN 90 DEG INTERVALS
FIRST CORRECT AXIAL & THEN RADIAL ex.
AXIAL TOP:0, LEFT:+0.3, RIGHT:-0.6, BOTTOM:-0.3MM
THE ABOVE READING MEANS THE SHAFT IS CLOSED LEFT SIDE BY
+0.3 AND OPEN BY -0.6. CORRECT BY MOVING THE SHAFT TO
CLOSE -0.6 AND CHECK WEHER IT IS O.OOMM FOR SIDE
CORRECTION. AND FOR BOTTOM -0.3 MEAN BOTTOM SIDE IS OPEN.
CORRECT BY ADDING SHIM ON FRONT BRG PEDESTAL OR REMOVING
SHIM FROM REAR BRG PEDESTAL WITH THIS FORMULAE.
'(AV x L / 2D)' AV=-0.3(ERROR), L=LENGTH OF CEN OF BRG
PEDESTAL, D=DIA OD SHAFT WHER THE DIAL IS PLACED.
RADIAL TOP:0, LEFT:+0.3, RIGHT:+0.5, BOTTOM:+0.8MM
THE ABOVE READING MEANS THE SHAFT IS OUT FROM ITS CENTRE
AXIS BY 0.2MM RIGHT SIDE, JACK 0.1MM FROM RIGHT TOWARDS
LEFT. AFTER THAT CHECK WETHER IT IS O.OO. AND FOR BOTTOM
+0.8MEANS MOTOR IS DOWN SO PLACE +0.4MM SHIM ON ALL FOUR
LEGS/BRG PEDESTALS.
AFTER THAT CHECK THE READING. THE ALGEBARIC SUM LEFT&RIGHT
WILL GIVE THE BOTTOM READING CONSIDER ALONG WITH SIGNS
ie:+OR-
| Is This Answer Correct ? | 18 Yes | 1 No |
Post New Answer View All Answers
compare brayton and otto cycle
DEAR SIR, I NEED A MODEL QUESTION PAPER OF JSPL. i'M IN mechanical BRANCH. E-MAIL ID:sksuman289@gmail.com
with the aid of schematic and block diagram describe the control system involved in a student passing a control system engineering examination.use standard terminologies and specify all the system component involved.
distance between the power generation and the distribution to the application is fixed or vary
Explain why do the radiators in your house click when you start the heating system?
What parameters to be reported when we send lubricating oil for shore analysis?
What do you measure in the banana and mountain diagram?
How does iron ore turn into steel?
How do you determine what suction pressure should be in r22 air conditioning compressors suction line?
When looking at a flanged extension pipe and it is labeled DN20, just what does that mean or intel?
What are the major effects of alloying elements?
Which parameter remains constant in a throttling process ?
Are you ready to relocate with your immediate family as a new employee?
What is the different types of surge tanks ?
Explain how do you determine what suction pressure should be in r22 air conditioning compressors suction line?
