Interested to Buy Any Domain ? << Click Here >> for more details...
Hello, im taking an introduction to PLC..and i'm having a
hard time on creating a program for 2 lamps blinking
alternately with this button characteristics:
1.) One push button (starts upon pressing)
2.) Same push button (when pressed again, will pause the
system)
3.) Same push button (when pressed again, will continue the
paused system)
4.) Same push button (when pressed within 2 seconds, will
shut off the system)
Pls..i know this is just a simple problem for you guys..
- 2 Answers
- 4489 Views
- I also Faced
- E-Mail Answers
Answer Posted / milind
you have to keep latched the push button(start) in programe
and have to off the o/p coil when next pressed again.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
suri transmission
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
how to calculation increase power factor for single phase
What is an ac motor?
why electronic instruments is more favorable than electrical?
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
what is the principle of operation of CFL ??
Hi Everyone ! My Name is Hakim ullah khan please i need formula of Cable Rating because i want to calculate by self without check any Table Chart... Thank you.....
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
During underground cabling in landscape area what did we cover the cable with to prevent the electric shock & protect the cable?
what is droop control?
what is the voltage rating of chiller unit sensors
List the advantages of star-delta starter with induction motor?
