On what basis primary and secondary of a transformer is
chosen?
Answer Posted / iamdon
The function of a transformer is to transform level of
current and voltage from SOURCE to LOAD side while
maintaining the same frequency.
The ONLY CRITERIAON which govern the choice of primary and
secondary is as follows...
Primary side:Where source of power is connected.
Secondary side:Where the load is connected.
Primary and secondary are NEVER BE SELECTED on the
following bases
1)Voltage rating
2)Number of turns
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
What is the difference between grid and off- grid system??
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
give single line diagram of D.G distribution form alternator to main L.T panel?
How we calculate the size of ht cable for any transformer
what type of earthing do for dry fissure rock?
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
Ceiling Fan and Storage type water heater. Discuss
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....
sir i want previous entrance exam papers for written test
Why efficiency of generator is higher than motor at a particular load?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
You are of electrical field and you are going for software? Why
Differentiate between ideal and non ideal current sources?
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com