Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajesh rathore
automation is delgetion human control of techanicle
equpmentfor increace the productivity and better quality,
increasing the safety of working condition and redusing the
manpower cost& cost of the money.
| Is This Answer Correct ? | 23 Yes | 4 No |
Post New Answer View All Answers
a governer in an Ic engine controls the
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
What is meant by reactance voltage?
Dyn1 transformer vector group testing how to do
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
what is the difference between fault current ant short circuit current?
Why is tan-delta test and capacitor measurement done on alternator?
how to meas-our losses for L.T & H.T
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
Describe the test procedure to determine the vector group
impliment (AB)`+C to transistor representation
How PSV sizing being done
difference between Ac and Dc mcb ????
