Interested to Buy Any Domain ? << Click Here >> for more details...
what are the main problems that happen in an emergency
light and how to fix them ?
- 2 Answers
- 5859 Views
- I also Faced
- E-Mail Answers
Answer Posted / iamdon
The major problem faced with emergency light is related to
battery.
1)Overcharging:For quick charging,charging done beyond the
rated current and voltage level which would had not been done.
2)Prolong operation at under charge state: May permanently
damage the electrodes of battery.
3)Incomplete wire connection. etc
If rest part is working fine then only option left is to
replace the battery with proper one.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
what is inter connected dc generator?
How does an induction motor start?
State the factors, for the choice of electrical system for an aero turbine.
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
What is the end effect of linear induction motor ??
What if the difference beween internal and exrteranal LBB?
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
what is EIB lighting control system? what is the advantages of this system?
How to calculate Voltage regulation of 22 KV Over head Line.
how electical engineer is related to apsrtc (general) post? if they ask a question in interview as why did u choose this job what shd be answer
What is the meaning of floating point earthing in battery backed systems ?
