Answer Posted / xv2ps

I also thought yes as above described.
However, we have some electric problems in our factory for
2-3 days with one phase screwing off.
I have signed to rewire over 15 motors.

How to see the inductance in a transmission lines

1679

---

how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.

1747

---

What is servo motor? what is its purpose?

1607

---

Is there any abbrevation for STUB in Stub bus protection

1504

---

why is control bus bi-directional?

1719

---

---

I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?

12311

---

how can you size an automatic voltage regulator?

1882

---

What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?

1351

---

what are the difference between PLC and embedded

1660

---

In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because

783

---

Difference between megger test equipment and contact resistance meter test instruments?

917

---

For RCD (Residual current device) Icu is defined. How i can find Ics for them?

1608

---

how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.

1477

---

In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..

1444

---

1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor

4284

---