HOW CAN DESIGN LENGTH,WIDTH AND HEIGHT THE FOUNDATION FOR
THREE FLOOR BUILDING?
- 3 Answers
- 9291 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhai
we can desigh length width and height of the foundatio for
three floor building considering the bearing capacity of
the soil, the consolidation of the soil and type of the
soil.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Spider cracks occur in beam bottom due to––
how to remove the quantity of metal 1 and metal 2 in concrete
What is the use of extend command?
Dear Engineers, Can you please advise me the material requirement to construct a room 4 M x 4 M 1. No. of Standard Brick 2. Requirement of Cement Bags 3. And Concrete for Steel, Cement, sand, etc Thanks
what is work of planning deptt. in any construction compny (in road project)
How do you calculate the power of centrifugal pump?
What is thumb rule in quantity and cost estimation of a residential building?
How do You Maintain a structure after getting cube test of low strength.
which is the cheapest type of flooring (say for using for 6 months in a factory building & dismantling it)?
what is the composition of good brick ?
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
if mineral admixture add into concrete then what is the differences between full cement concrete & fly ash added concrete of their SP. Gr.?and for the changes of SP. Gr. what is the changes in concrete
how to do sudoko puzaals?
insted of bentonite we can use any alternate material in piling ?
what is the metal ratio in granular subbase coarse for one cum ? And please explain the morth table ...what is the difference between grading 1 , 2, 3 what it means..plz explain
